
Enthusiast builds balancing power and reliability
Fits the SXT V6 (3.6L Pentastar V6) only.
aFe Power
MPN: 77-42011
View on aFe Power website+10
Horsepower
+21
Torque (ft-lbs)
Enthusiast builds balancing power and reliability
Fits the SXT V6 (3.6L Pentastar V6) only.
A plug-in electronic module that connects to your engine's sensors to increase power output by adjusting fuel and timing maps, adding around 10 horsepower and 21 lb-ft of torque to your 3.6 L V6 Challenger. Who it's for: Daily drivers who want a simple power boost without opening the engine or doing major modifications. Trade-offs: Easy to install and remove, but may affect fuel economy and could potentially impact warranty coverage since it modifies engine parameters.
aFe Power Scorcher GT Power Module changes 1 primary stock component (highlighted red). Included or supporting pieces are listed below.
Loading 3D scene
0%
The build planner counts these as covered so you don't double-pay for parts this upgrade already addresses.
ECU Tuner / Programmer
Replaces stock
ECU Tune
addition
Specifications
5 attributes| Direct Plug Play Power | This quick and easy plug-and-play SCORCHER GT module adds significant power by altering MAP and IAT sensor signals, improving performance and throttle response.1 |
| High Quality Case Wiring Harness | aFe POWER SCORCHER GT modules use high quality aluminum extrusion black powder-coated enclosure casings and factory style connectors that require no modifications to your factory harness.1 |
| On Off Button | This module comes with a built-in blue L.E.D. light to show the module is powered up and functioning correctly.1 |
| Quality Precision | SCORCHER GT modules are 100% tested for proper protection.1 |
| Emissions Disclaimer | This product is not currently CARB exempt and is not available for purchase in California or for use on any vehicle registered with the California Department of Motor Vehicles.1 |
Sources: 1Afepower
Compare prices across 1 retailer — every link opens the real product page
Verified fitment includes 2022 Dodge Challenger. The full compatibility list is shown in the Compatible Vehicles section above; if your specific year/trim is not listed, double-check with the retailer before purchase.
Based on product data
This is rated as an intermediate install. Plan for a half-day with hand tools and basic mechanical experience.
Based on product data
On a stock vehicle this typically adds about 10 HP and 21 lb-ft of torque at the crank, measured against a baseline pull. Real-world numbers vary by altitude, fuel quality, and supporting mods.
Based on product data
Tuners & Programmers buyer's guide
How to pick tuners & programmers for your Challenger — what matters, what doesn't, and what to avoid.
Other tuners & programmers for your Challenger
Compare Side-by-Side
DiabloSport
inTune i3 Platinum Programmer

HP Tuners
MPVI3 Standard Kit

DiabloSport
Predator 2 Programmer

Diablosport
Trinity 2 Platinum Tuner and Modified PCM Swap Kit

aFe Power
SCORCHER GT Power Module

ID Speed Shop
Single Custom Tune